✔✔✔BeiLin

| Mobile/wechat：+86 18005021035

Email contact：18005021035@163.com

Product introduction：

Part number IS220PPDAH1B
Output voltage 28 volts DC
Number of self-diagnostic tests performed five
Installation position on JPDS, JPDC or JPDM board
Manufacturer GE Energy
Manual GEH-6721 Mark VIe Control Vol. II System Hardware Guide
Functional acronyms/abbreviations PPDA series
Diagnostic signals Two 115/230 VAC analog feedbacks, local ground signal, six fuses AC, etc
Ground fault detection using JPDE board

IS220PPDAH1B

IS220PPDAH1B is an I/O package from Mark VIe.
The backplanless and Ethernet-based Mark VIe distributed control solution improves system availability and simplifies operation and maintenance throughout the life cycle.
The foundation of the Industrial Internet relies heavily on Ethernet transmission. As an alternative to rack-based control, the Mark VIe system uses this flexible, high-speed, low-cost communication at the lowest level of control system design.
I/O can be distributed or centralized, and master and security controls can coexist on the same network while remaining functionally independent.
In addition, the master controller can listen for safe inputs without interference, reducing the cost of field instrument duplication.
For programming, configuration, trend analysis and analysis of the diagnostics of marked controls and associated systems, the ControlST* software suite is used, which includes the ToolboxST* application software.
It provides high-quality, time-consistent data at the controller and plant level, allowing for more efficient management of control system equipment.

The IS220PPDAH1B board is a distribution system feedback model produced by General Electric for the Mark VIe system.
The model is used to regulate the feedback signals of the circuit board, and can also provide an Ethernet interface for the connected controller.
Feedback from the battery pack is plug-and-play, and it will use the plugged electronic ID to determine the power of the connected distribution model.
The information from the distribution model will continue to be used to occupy the IONet output to provide the correct feedback from the connection.
While the IS220PPDAH1B package is compatible with JPDC, JPDS, JPDM, and JPDG power boards, it is only compatible with feedback signals from JPDB, JPDF, and JPDE boards.
Typically, this PPDA package is mounted on one of the following boards; JPDM, JPDC, or JPDS. The pack can be connected to more boards using 50-pin ribbon cable jumpers through wiring of the pin-to-pin connector.

✔✔✔Our advantage

1.Deep discount

2.Special price, limited time special price

3.Fast delivery and one year warranty!

4.24/7 service and free online quotes

✔✔✔Learn more

✔✔✔How to ship?

≈For goods that are available, we will place an order upon receipt of payment。

≈We can ship all over the world through SF Express and Federation.The packing is very strong.

If you have any special needs, please let me know

≈You can expect to receive the item approximately 7 days after we send it.